最終更新：

弊社のアプリと設定を使用するには、まずExpressVPNアカウントに登録してください。

This guide will show you how to resolve the installation error that says “The installation failed” when trying to install the ExpressVPN app for Mac.

The installation failed” error appears when you are trying to install the ExpressVPN app.This installation error is caused by the incorrect /temp folder permissions on your Mac.

Preliminary check

Before you proceed, confirm that you are experiencing the same installation error addressed in this guide. To confirm this, check if the following error message also appears in your installation log:

PackageKit: Install Failed: Error Domain=NSPOSIXErrorDomain Code=1 "Operation not permitted”

To locate the error message:

  1. Open Spotlight by pressing Command-Space bar.
  2. Enter console.app.
  3. In Console, click Log Reports.
  4. Double-click install.log to open the file.
  5. In your log, search for the error message:

PackageKit: Install Failed: Error Domain=NSPOSIXErrorDomain Code=1 "Operation not permitted”

If you do not see this message in your log, the installation error you are experiencing could be different from the one addressed in this guide. For the appropriate troubleshooting steps, contact the ExpressVPN Support Team for immediate assistance.

If you see the error message in your log, following these steps to resolve the issue:

  1. Restart your Mac. After the chime, hold down Command-R.
  2. Click Utilities > Terminal.
  3. Run the following command: /usr/bin/csrutil disable
  4. Restart your Mac again.
  5. Open Terminal. Run the following command:/usr/bin/sudo /bin/chmod 1777 /tmp Run the following command: /usr/bin/sudo /bin/chmod 1777 /var/tmp Run the following command: /usr/bin/sudo /usr/bin/chflags -R norestricted /private/tmp/
  6. Restart your Mac. After the chime, hold down Command-R. Click Utilities > Terminal.
  7. Run the following command:/usr/bin/csrutil enable
  8. Restart your Mac and launch the ExpressVPN app installer.

You should now be able to run the ExpressVPN app installer normally. If you are still unable to run the ExpressVPN app installer, you can perform a clean installation of the ExpressVPN app:

  1. Open Terminal. Run the following command:/Applications/ExpressVPN.app/Contents/Resources/uninstall.tool
  2. When prompted to uninstall, enter Y.
  3. Enter the password for your Mac.
  4. Restart your Mac and relaunch the ExpressVPN app installer.

Need help? Please contact the ExpressVPN Support Team for immediate assistance.

Back to top

この記事は役立ちましたか？

ご不便をおかけして申し訳ございません。よろしければ、今後の改善策をお聞かせください。

サポートチームのメンバーがこの問題についてフォローアップいたします。